For the majority of homeowners, a pool pump is one of the most important pieces of equipment in your home. It's responsible for circulating water through your pool and filtering out debris so that you can enjoy swimming in clean and clear water all year long.
While it's not uncommon for many people to forget about their pumps until they stop working, this article will provide several tips on pool pump repairs Melbourne so that you don't have any issues with it when it comes time for use during those hot summer days!
Fix or Replace the Pump Lid O-Ring
By far the most common problem with pool pumps is a leaky lid. If a small amount of water escapes from beneath your pump's lid every time it shuts off, you've probably got an o-ring that has become unseated.
It's really just a rubber ring that fits between two parts of the housing. Some pools have more than one o-ring; if your pool does, there's usually some kind of marking on both parts to show where each part goes.
The smaller the number sequence is, the less important it is for keeping water out; in general, if you're ever unsure whether two parts should be lined up exactly or not, err on their being in misalignment by 1 millimeter or so (less than half an inch).
Replacing an o-ring is simple: pull off each end cap and remove any gaskets under them—these are pressurized to seal against each other when everything else is together.
Then slide off any gasket rings around them as well—they don't need to be removed for this repair—and pull out both ends at once with pliers after having first disconnected any power supply wires from them (you'll also need to unplug everything from inside before trying this).
Check the Drain Plug
If you've noticed that your pump is not draining as it should, it could be because there's a blockage in the drain line.
To check if this is the case, remove the plug from the pump and look inside to see if there is anything obstructing it. If so, use a wire hanger or other tool to clean out any debris before replacing the plug.
If there isn't anything in your pool pump's drain line when you remove its plug, then check for leaks at either end of this hose by placing something absorbent underneath where water usually collects on top of concrete or pavers (often at an angle).
If you notice water coming up through these areas after running your pool for several hours, replace both sections of hose before continuing with repairs—they're inexpensive enough that replacing them will save time and money down the road!
Inspect the Pump Basket and Skimmer Basket
After the pool pump has been running for about 15 minutes, use your pool cleaner to inspect the pump basket and skimmer basket. If you have a pressure gauge, check it too.
Check for damage to the baskets and also check them for debris. Also look for signs of rust or corrosion in these areas. These can be signs that parts need replacing or repairing before they fail completely, which will result in an expensive repair bill!
Conclusion
We hope you found this article informative and helpful. We know how frustrating it can be when the pool pump stops working, so take the help of an expert if you need any assistance with your pool pump repairs Melbourne needs.